It can be just two sources, or it can be multiple. Use the icons at the bottom of the screen to select which sources will be a part of the communication channel. This means, for example, the host can communicate with a remote guest prior to introducing them, or all the participants can talk to each other to discuss the next segment whilst other audio is playing. ‘Back Channel’ allows you to set up a communications link between audio sources that will not be recorded. The major benefit of this is that you can now apply different effects to each microphone channel, and these effects are recorded on individual channels in multitrack recording mode, rather than just the main stereo mix. In order to apply effects to multiple microphone channels, you will need to set up and trigger an effect pad per channel. This switches between two trigger modes: if ‘Latching’ is engaged (highlighted), then pressing the pad will activate the effect, and it will stay activated until the pad is pressed again if it is not engaged, the pad will only trigger the effect whilst it is being pressed.Īs of firmware version 1.1.1, you can only assign one microphone channel to an effect pad at a time. Next to the mic selection buttons is a control labelled ‘Latching’. At the top of the screen, you can select which of the four microphone channels the effects will be applied to. To create or edit an effect pad, go to the pad edit screen and either clear a pad and then select ‘FX’ as the type, or click ‘edit’ for an existing FX pad. Replay/Continue: When in ‘Toggle’ mode, this sets whether playback starts from the beginning (if the pad is pressed after being stopped) or resumes from the pause position. Loop: In this mode, the audio will play repeatedly in a loop until playback is stopped (note: this mode is not available in ‘One Shot’ mode). ‘Hold’ will play the sound for as long as the pad is pressed. ‘One Shot’ means pressing the pad will play the sound from the beginning – repeated presses will restart playback from the beginning (note: you cannot force stop playback in this mode – either let the sound play out or fade the sound out manually). ‘Toggle’ means one press will start the sound and a second press will stop it. Toggle/One Shot/Hold: This setting affects how the audio triggers when you press the pad. There are three parameters you can adjust: If you’re using RØDE Central, go to the ‘Customize SMART pads’ screen and click on the pad you want to edit. To access these on the RØDECaster Pro II, tap the target pad from the main screen and then tap ‘Edit’. There are multiple audio playback modes for the sound pads.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |